The DZ-98B motor grader
its modifications and complete sets (called hereinafter the motor graders) in question are intended for use in highway engineering for performing the earth-moving and grading jobs on soils of the I, II, III and IV categories. They are widely used in railway, airfield, land reclamation and hydrotechnical construction.It is advisable to use the motor graders when performing especially high-volume power-consuming earth-works under heavy road conditions.
For example:
1) construction and overhaul of the dirt and gravel roads;
2) construction of the pit for the road foundation in the earth road bed;
3) moving of earth in the embankment;
4) levelling of the fill-up soil and grading of surface;
5) moving of the inertia materials wiith the stabilizing admixtures while mixing them in transit;
6) scarifying (ripping of soil and worn-out roadbeds);
7) grading of surface of large territories;
8) cleaning of snow-bound roads and territories.
The motor graders are available in two design modifications depending on the climatic conditions:
- conventional modification for operation in middle latitudes at the ambient air temperatures from minus 45 to plus 400 C;
- tropicalized modification for operation in the regions with tropical humid and dry climate.
Motor grader class | 250 |
Width (blade in transport position), mm 3 | 3220 |
Height (without flashing beacons), mm | 4000 |
Wheel base, mm | 6000 |
Front wheel tread, mm:
narrow | 2622 |
wide | 2696 |
Rear wheel tread, mm: narrow | 2502 |
wide | 2576 |
Ground clearance, mm: under mould board in transport position | 350 |
under front axle | 615 |
under rear axle | 440 |
under suspension of intermediate and rear axles | 395 |
Mass of motor grader, kg: operational | 19500 |
on front axle | 5660 |
on intermediate and rear axles | 13850 |
Static ground pressure at operational mass, N (kgf): on blade set square to longitudinal axis | 103000(10500) |
on scarifier teeth | 45400(4630) |
Number of gears: forward movement | 6 |
reverse movement | 6 |
Travelling speed of motor grader at
engine crankshaft rated speed,km/h:
forward: I gear |
3,5 |
II gear | 5,51 |
III gear | 9,75 |
IVgear | 14,1 |
V gear | 22 |
VI gear | 41 |
reverse: gear | 4,22 |
II gear | 6,64 |
III gear | 11,72 |
IV gear | 16,9 |
V gear | 26,6 |
VI gear | 47 |
Minimum turning radius, when travelling dry concrete surface, m | 18 |
Holding gradient of motor grader by parking brake, %, not less than | 15 |
Braking distance of motor grader travelling at initial speed of 30 km/h on horizontal section of dry asphalt road with clutch disengaged, m, not over | 14 |
Braking distance of motor grader travelling at initial speed of 30 km/h with emergency braking system applied (one of circuits failed), m,not over | 41 |